Set firewall modify PIA_VPN_ROUTE rule 1 source group address-group PIA_VPN_COMPUTERSДЄpply Firewall Modify Rule: This rule should be applied inbound to your LAN interface. Set firewall modify PIA_VPN_ROUTE rule 1 modify table 1 Set firewall modify PIA_VPN_ROUTE rule 1 description 'traffic from Devices to vtun1 (PIA)' Set firewall group address-group PIA_VPN_COMPUTERS description 'PIA Hosts'ДЇirewall Modify: This rule creates table 1 and indicate that my source hosts (the ones that will be routed through Open VPN) set firewall modify PIA_VPN_ROUTE rule 1 action modify Set firewall group address-group PIA_VPN_COMPUTERS address 10.1.1.51 set firewall group address-group PIA_VPN_COMPUTERS address 10.1.1.50 Below commands will add a couple of IP addresses to the group and name it. configureДЇirewall Address Group: Includes the IPs of the hosts I want to route through the Open VPN connection. SSH into the router and get into configuration mode. Upload files to /config/auth вЂ“ Why config/auth? In this dir they wonвЂ™t get deleted if you do a firmware upgrade.Configure a static route sending hosts from table 1 (specified in firewall modify rule) through interface vtun1.Instead of this example that uses вЂ5001вЂ™. If you put it after it wonвЂ™t work so your configuration might as well use another rule number Note: This rule should be before your global NAT configuration, Apply Firewall Modify Rule to LAN Interface.If you donвЂ™t do the address group you can assign the IP directly in the firewall modify rule. You can also use this group in my NAT configuration. I did this because I have multiple IPs that will use the VPN and if I want to add another host later on, I just have to add the IP in the address group, no need to modify all VPN configuration. I am using an EdgeRouter 4 running firmware v2.0.8 and OpenVPN v2.4.0 Overall Steps: This guide will assist you with configuring your EdgeRouter to funnel traffic for certain IPs through PIA VPN servers.

Edgerouter pia vpn client